FS125
2.10 Illumination
The machine is designed for use in daylight! The
machine operator / owner must ensure sufficient
workplace lighting for non-illuminated work sites!
2.11 Oils, greases and other chemical
substances
When handling hydraulic fluids, lubricants, greases or
preservatives (referred to hereinafter as fuels and
lubricants), the safety regulations which apply to the
respective machine are to be observed!
Avoid long contact of the fuels and lubricants with your
skin! Careful cleaning of the skin from adhering fuels
and lubricants is necessary.
Be careful when handling hot consumables (risk of
burning or scalding) particularly at liquid temperatures
above 60°C, avoid any skin contact with these liquids!
If you get fuels or lubricants in your eyes, rinse them
immediately and carefully with potable water. Then
consult a doctor.
Remove flown out fuels and lubricants immediately!
Therefore use a binder.
Fuels and lubricants must not seep into the soil or into
the public sewage system! Fuels and lubricants which
can no longer be used are to be collected, properly
stored and to be properly disposed of.
The respective regulations and laws for handling fuels
and lubricants which are valid in the country of use are
to be observed and adhered to. This also applies to
the disposal of such fuels and lubricants. To inform
yourself turn to the responsible authorities.
2.12 Transport
Use only suitable means of transport and lifting gear of
sufficient capacity when loading or transporting the
machine! Appoint an experienced instructor for the
lifting operation!
Always observe the instructions given in the operating
manual when lifting the machine (use only the
prescribed lifting eyes for attaching the lifting gear)!
Use only suitable transport vehicles with sufficient load
capacity! Secure the load carefully. Use suitable
fastening points for securing!
Before loading the machine or parts of it, secure the
machine against inadvertent movement! Attach a
suitable warning sign!
The blade must be removed for transport. Even in
case of a minor change of location, the engine must be
stopped!
Before using the machine again, make sure that such
protection material or devices are properly removed!
Parts which had to be removed for transporting of the
machine must be refitted and secured carefully before
the machine is used again!
Before setting the machine in motion always check
that all accessories are safely stowed.
The recommissioning procedure must be strictly in
accordance with the operating instruction! Observe the
instructions given in the operating instruction when
reassembling and operating the machine.
Attention: Check that all parts of the
machine are well fastened before
transporting. Before transporting the
blade must be removed!
For loading, only use lifting gear and
tackle of sufficient capacity. Lift the
machine using the lifting eye.
During cuts displace the machine
only with non-rotating blade (not
running engine)!
2.13 Store
Store the machine in a dry, high or locked place, out of
the reach of children or unauthorized persons. Clean
and preserve the machine with corrosion preventive if
storing over a longer time like winter time!
Note: Store dismounted blades so, that the blades not
exposed
to
mechanical
environmental conditions (UV radiation, temperature,
humidity, etc.).
Attention: Store blades just standing
or hanging!
3.
Preparing for Operation
3.1
Export checking
Remove the transport packaging and dispose of it in
an environmentally responsible way. Check the
machine for completeness and intactness. For the
- 28-
Lifting eye
Injury hazard: Down coming
parts!
damages
and
5009002-00
BA-DE-GB-FR-NL (001)
®
harmful