Power Supply - GÖLZ ST 85 Mode D'emploi

5.5 Cutting material
Insert the cutting material, push it against the stop rail and the
side stop rail against the cutting material. For angle cuttings
loosen the clamping lever and move the cutting head into the
required cutting angle. Fasten clamping lever.

5.6 Power supply

Check the electrical condition, input voltage 230 V, 50 Hz or
115 V, 50/60 Hz. The used power supply must comply with
the regulations of power distribution on building sites (fuse
protection over FI-protected switch). Completely uncoil ex-
tension cables. The switch must be in 0 position. Insert in
the mains plug.
6. Operation
Check all safety devices are fixed!
Keep unauthorized persons away!
6.1 Starting the electric motor
Check the suction strainer of the water pump is fully under
water, otherwise the water pump may be damaged!
Start the electric motor pushing the START- knob of
the switch. The water pump will also be set in motion.
Open the water valve at the blade guard.
6.2 Feed
Operate with even feed and in dependence to the
material to be cut.
• Feed to high - motor overstress!
• Feed to low - dull segments!
6.3 Stopping the electric motor
After operating stop the electric motor pushing the OFF-knob of
the switch and drain of the water.
Switch
17
Cutting material
Stop rail
Clamping
lever
Scale
Side stop rail
Start
Handle
OFF