Lubrication - LGB Sachsische II K Mode D'emploi

SERVICE

Lubrication

The axle bearings and the side rod bearings should be lubri-
cated occasionally with a small amount of Märklin-Oil (7149).
Replacing the smoke generator
• Pull the safety cover out of the smoke stack (Fig. 4).
• Use pliers or tweezers to pull the old smoke generator out
of the stack (Fig. 5).
• Cut the wires to the old generator and attach them to the
replacement generator.
• Insulate the connections and push the replacement
generator into the stack (Fig. 6).
• Reassemble.
Replacing the traction tire
• Remove screw on wheel together with the traction tire.
• Pull off side rod.
• Use a small, straight screwdriver to replace the old
traction tire:
• Pry the old traction tire out of the wheel groove.
• Gently push the new traction tire over the wheel and into
the groove of the traction wheel.
• Make sure that the traction tire is seated properly in the
wheel groove.
• Reassemble.
7