ETNA A126VWRVS Notice D'utilisation page 55

FAULTS
FAULT
The burner does not burn
evenly.
The burner goes out after
igniting.
CAUSE
Burner parts incorrectly
installed.
Burner parts dirty or damp.
Control knob not kept
pressed in long enough
(appliances with
fl ame failure device).
GB 11
Faults table
SOLUTION
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outfl ow holes are open.
Keep the control knob
pressed in for at least 5
seconds.