Mounting Or Removing Of Push Bar - Vermeiren V300 30 Mode D'emploi

2.2

Mounting or removing of push bar

L L L L
WARNING:
Risk of injury - Make sure that buttons Ⓐ Ⓐ Ⓐ Ⓐ is tightened.
L L L L
WARNING:
Risk of injury - When equipped with the push bar, the push bar shall
always be mounted (→ to increase the stability of the back).
The mounting of the push bar Ⓑ is done as follows:
1. Mount the push bar Ⓑ with the starknob Ⓐ in the left hand-grip.
2. Swing the push bar Ⓑ to the right.
3. Mount hook Ⓒ over the right hand-grip Ⓓ as shown on the drawing. Use holes
adjust the tension of the backrest.
To take off the Push bar:
1. Loosen the starknob Ⓐ on the right hand-grip.
2. Remove hook Ⓒ from the right hand-grip Ⓓ.
1. Pull handle on both sides towards the grab
handle to adjust the backrest.
2. The pen Ⓐ comes out the groove of the
toothed plate Ⓑ.
3. Pull both back tubes backwards continuously
to the desired position (4 different positions: 5°
- 15° - 25° - 35° ).
4. Check that the pen Ⓐ is well fixed in the
groove of the toothed plate Ⓑ.
If your wheelchair features drum brakes, the
handles are used as brakes.
(add to manual V300)
Page 3
V300 30°
2012-08
or to