Starting The Engine - Shindaiwa EC7500 Manuel D'utilisation

Starting the engine

Starting a cold engine
WARNING!
■
Before starting the engine, place
the unit on a clean, level surface.
Make sure you have good secure
footing and always keep a firm grip
on the unit.
■
Move at least 3 meters away from
the fueling site before starting the
engine.
■
Make sure the cut-off wheel is
well clear of obstacles. The cut-off
wheel may rotate when the engine
starts.
■
Keep bystanders well away.
■
Never start the engine without a
cut-off wheel installed.
1. Turn the on-off switch On.
2. Depress the primer pump a few times
repeatedly until the primer pump is
almost filled with fuel. See Figure 10.
Choke
Figure 10
Starting a warm engine
1. Turn the on-off switch On.
2. Push the decompression valve in.
3. Pull the choke all the way out and push
it back to the original position (choke
open). The throttle is automatically set
at a fast idle position.
If the engine doesn't start
If the engine fails to start, repeat the
appropriate starting procedure for a cold
or warm engine.
3. Push the decompression valve In.
4. Pull the choke all the way out (choke
closed). The throttle will automatically
be set to fast idle. See Figure 10.
5. Place the unit on firm ground.
6. Secure the unit by placing your right
foot inside the rear handle and your left
hand on the front handle. See Figure 11.
Figure 11
7. Grip the recoil starter handle with your
right hand, pull the starter cord slowly
until you feel the starter engage, then...
8. ...start the engine by pulling the starter
cord upward rapidly.
The throttle trigger can not be moved
Primer
Pump
without first depressing the lockout lever.
Operating the throttle will automatically
disengage the fast idle setting.
4. Follow Steps 5 though 12, Starting a
Cold Engine.
IMPORTANT!
WARNING!
Keep well away from fire!
CAUTION!
■
The recoil starter can be damaged
by abuse.
■
Never pull the starter cord to its full
length.
■
Always engage the starter before
cranking the engine.
■
Always rewind the starter cord
slowly. Do not just let go of the cord.
9. When the engine fires, push the choke
in to its original position (choke open).
10. If the engine does not continue to run,
pull the recoil again.
11. As the engine starts, clear excess fuel
from the combustion chamber by rev-
ving the engine several times.
12. Let the engine run at idle speed for 2-3
minutes to warm up.
WARNING!
The cut-off wheel must not
rotate at idle speed. If it rotates,
reduce idle speed by adjusting the
idle adjust screw.
9