Shindaiwa EC7500 Manuel D'utilisation page 12

Operating (continued)
Reversing cutting head for flush cutting operations
WARNING!
Before performing any work
on the cut-off saw, make sure the
engine is stopped and the ignition
switch is OFF.
NOTE:
For units equipped with a water kit, loosen
the (2) water nozzles and disconnect the
main water line from the double nozzle.
1. Remove the cutting wheel (Refer to
Section Mounting the Cut-off Wheel).
Using a Phillips screwdriver, loosen the
tension screw until the tension indicator
is all the way to the front of the scale.
See Figure 16.
Remove Cutting Wheel
Tension Screw
Figure 16
2. Back off tension screw another 4-5 turns
so that adequate clearance is achieved
where the tension screw contacts the
mount when the mount is turned over.
See Figure 17.
Tension Screw
Figure 17
12
3. Using a 6mm hex wrench, remove the
two belt guard bolts and slide the belt
guard forward to remove. See Figure 18.
Figure 18
4. Remove the blade mount from the
mounting surface and rotate the blade
mount 180
hand side of mounting surface. See
Figure 19.
Loosen Two
Bolts
Tension
Indicator
Figure 19
5. Making sure that the drive belt is fully
engaged in the drive pulleys, slide the
belt cover on and install the two socket-
head bolts into the left-hand side of the
mounting surface only until the bolts
bottom on the belt cover. See Figure 20.
Mount
Belt Guard
6mm Socket-
Head Bolts
0
, then remount to the right
6mm Socket-
Head Bolts
Figure 20
6. Adjust the tension screw until the
tension indicator is in the middle of the
scale. See Figure 21.
Figure 21
7. Tighten the two mounting bolts securely.
8. Reconnect the main water line, adjust
and retighten water nozzles (if equipped
with a water kit).
9. Reinstall the cutting wheel. Back off
tension screw another 4-5 turns so that
adequate clearance is achieved where the
tension screw contacts the mount when the
mount is turned over. See Figure 17.