Inspection And Maintenance - Shindaiwa EC7500 Manuel D'utilisation

Découpeuse thermique
Masquer les pouces Voir aussi pour EC7500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Inspection and Maintenance

IMPORTANT!
MAINTENANCE, REPLACEMENT,
OR REPAIR OF EMISSION CONTROL
DEVICES AND SYSTEM MAY BE
PERFORMED BY ANY REPAIR
ESTABLISHMENT OR INDIVIDUAL.
HOWEVER, WARRANTY REPAIRS
MUST BE PERFORMED BY A DEALER
OR SERVICE CENTER AUTHORIZED
BY SHINDAIWA CORPORATION
AND USE OF PARTS THAT ARE NOT
EQUIVALENT IN PERFORMANCE AND
DURABILITY TO AUTHORIZED PARTS
MAY IMPAIR THE EFFECTIVENESS OF
THE EMISSION CONTROL SYSTEM
AND MAY HAVE A BEARING ON THE
OUTCOME OF THE WARRANTY CLAIM.
WARNING!
Inspection and maintenance
should be done in a well ventilated
place and where there is no risk of fire.
Cleaning the Air Cleaner
Dust in the air cleaner will affect engine
life. The air filter must be cleaned every
time you start operating.
Clean the air filter once a day and
replace the filter ever y 20 hours of
operation according to the following
procedures. See Figure 22.
1.
Pull the choke lever out so that dust will
not enter the carburetor.
2.
Unscrew the knob on the cleaner cover
and remove the cleaner cover and filter.
3.
Remove the pre-filter from the filter.
4.
clean the pre-filter with soap and water
and let dry.
5.
If compressed air is available, blow air
from inside the filter to remove dust. If
compressed air is not available, remove
dust by gently tapping the element on a
hard surface.
6.
Replace the pre-filter onto the filter and
reassemble them into the filter housing.
Make sure both filter bolts are securely
tightened.
Inspection and Maintenance Requirements
Item
What to do
Air cleaner
Clean
Cut-off wheel
Clean and
sharpen
Bolts/screws
Check and
retighten
Fuel cap
Check for leakage
Fuel tank
Check for leakage
Wheel guard
Check function
Clutch bearing
Grease
Belt
Check and adjust
Spark plug
Check and clean
Cylinder fins
Clean
Fuel filter
Clean
Carburetor
Adjust
Choke
Remove the Filter and
Pre-filter
Figure 22
7.
Reinstall the cleaner cover and make
sure the knob is securely tightened.
Daily
Weekly
Monthly
Unscrew the
Knob
Pre-filter
EC7500.48
Filter
IMPORTANT!
When cleaning the filter, the filter housing
and the inside of the cleaner cover should
also be cleaned.
As Required
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ec7600

Table des Matières