Shindaiwa EC7500 Manuel D'utilisation page 16

Découpeuse thermique
Masquer les pouces Voir aussi pour EC7500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Inspection and Maintenance (continued)
Replacing the Cut-off Wheel
1.
Make sure the ignition switch is Off and
the engine is stopped.
2.
Insert a 6mm hex wrench into the hole
in the belt guard to prevent the drive
shaft from turning. See Figure 29.
3.
Loosen the outer flange bolt with the
wrench and remove the bolt and outer
flange.
4.
Before mounting a cut-off wheel, deter-
mine its arbor diameter. If necessary,
remove the snap ring from the arbor,
install the correct collar, then re-install
the snap ring.
WARNING!
Using the wrong size collar
may lead to failure of the wheel or the
unit and could result in serious injury.
5.
Remove the old wheel and install the
new one. Make sure the inner bore is
properly set onto the collar.
Sharpening a Diamond Cut-off Wheel
While running the engine at low speed,
make about 10 passes at cutting a concrete
block or a soft brick. Keep the block
watered while sharpening.
Checking the Fuel Filter
WARNING!
KEEP AWAY FROM FIRE
OR EXCESS HEAT!
1.
Remove the fuel filler cap.
2.
Take the filter out from the fuel opening
by using a hooked wire. If the filter is
hard and clogged with debris, replace it
with a new one. See Figure 31.
CAUTION!
Make sure the fuel line is not pierced
by the hooked wire. The fuel line can
be easily damaged.
16
Replacing the Cut-off Wheel
Hex Wrench
Figure 29
6.
Replace the outer flange and bolt, then
holding the hex wrench in the hole of
the belt guard, tighten the bolt with the
wrench.
7.
Make sure the cut-off wheel is securely
fastened and does not wobble.
CAUTION!
Make sure the rotating direction of
wheel corresponds to the one indicated
on the wheel guard. Make sure there is
no dust around the outer flange.
Hooked Wire
Fuel Filter
Fuel Filler
Cap
Figure 31
Belt Guard
cut-off wheel rpm rating is greater
than the speed indicated on the
wheel guard label.
Label Showing
Figure 30
3.
Put the filter back into the fuel tank.
Make sure the fuel tube is not bent and
the filter stays at the bottom of the tank.
4.
Put the fuel filler cap back and tighten it
securely.
Outer
Flange
Outer
Bolt
Flange
Wrench
Tighten
Loosen
WARNING!
Make sure the replacement
Label Showing Rated
and Maximum Spindle
Direction of
Speed
Rotation
EC7500.42
Diamond
Wheel Guard
Wheel

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ec7600

Table des Matières