Timer; Bridge; Advice On Using Cookware - Thermador PRD364WIGU Manuel D'utilisation Et D'entretien

Timer

Use the built-in timer like a kitchen timer. You can set the
duration for up to 99 minutes.
Note: The timer DOES NOT serve to automatically turn
off the cooking zone.
Setting the Timer duration
1. Tap ø¼´Á.
Notification ‹‹, and touch keys A and @ are
--
activated.
2. Set the desired duration by touching A or @.
Touch and hold the touch keys A or @ to increase
--
or decrease the set duration more rapidly.
Note: If after 10 seconds nothing is inputted the timer will
automatically turn off.
3. Touch ø¼´Á to confirm.
-- If confirmation is not received within 10 seconds,
the countdown starts automatically.
-- A signal sounds and the duration begins to count
down on the display.
After countdown of set time
An acoustic signal indicates that the countdown of the set
duration is complete. The display blinks slowly.
1. Tap ø¼´Á.
-- The display goes out and the acoustic signal
ceases.
-- The acoustic signal ceases automatically after
three minutes. The ‹‹ and ø¼´Á notification
continue to blink until the ø¼´Á touch key is
touched or a control knob is operated.
Correcting timer duration
1. Tap ø¼´Á and re-adjust the duration by touching
the A or @.
2. Tap ø¼´Á again to start the countdown with the
modified time.
Page. 7
Canceling countdown
1. Tap ø¼´Á, change duration to ‹‹ and confirm by
tapping ø¼´Á again.

Bridge

In addition to being used separately, the two cooking
zones can be bridged with the Bridge feature to evenly
heat longer pans and griddles. It consists of four inductors
that work independently of each other. If using the Bridge
cooking zones, only the area that is covered by cookware
is activated.
Activating the Bridge
1. Place the pan on the induction module over the two
zones, covering both cooking zones.
2. Turn the Zone 2 knob to
3. Turn the Zone 1 knob to a desired setting of 1 – 9 or
XHI.
-- The Bridge indicator will appear in the display
panel.

Advice on using cookware

To ensure that the cookware is detected and heat is
distributed evenly, correctly center the cookware:
Diameter smaller than or equal to 5''
(13 cm)
Place the cookware on one of the four
positions that can be seen in the illustration.
Diameter greater than 5'' (13 cm)
Place the cookware on one of the three
positions that can be seen in the illustration.
If the cookware takes up more than one
zone, place it starting on the upper or lower
edge of the flexible cooking zone.
.