Getting To Know The Induction Module; Parts Identification - Thermador PRD364WIGU Manuel D'utilisation Et D'entretien

Getting to know the induction module

Parts identification

Control knobs
The power levels are controlled
by the knobs on the front of the
control panel.
Control knob settings
OFF Turns the power to the Induction Module off.
1 – 9 Lowest heat level (1) to highest heat level (9).
®
XHI PowerBoost
The function temporarily increases the
maximum output of the selected cooking zone.
Bridge (right knob)
The two cooking zones can be bridged and
cooked on simultaneously.
Heat shift (left knob)
Where the pot is placed (Front | Middle | Back)
dictates the heat setting (Min | Med | Max).
Zone locations
Page. 5
Zone 1: Back half of the
module.
Zone 2: Front half of
the module.
Zone 1+2 To access
(Bridge): Bridge, set the
right knob to;
and the left
knob between
1–XHI.
Zone 1+2 To access Heat
(Heat Shift, set the
left knob to ú.
Shift):
Induction user display panel
3
1 2
9
Display panel
1 Cooking Zone and Residual Heat display
Continuously lit up: Cooking zone is on and/or
emitting heat. DO NOT touch the cooking zones as
long as the Hot Surface light is lit up, even if the
cooking zone is already turned off.
2 XHI indicator
XHI (PowerBoost) is working for either zone.
3 No Pot indicator
Indicates that no cookware is detected.
4 Timer and error display
Shows the countdown time and any error messages.
5 MIN | MED | MAX indicator
The current power level for the Heat Shift function.
6 Heat shift indicator
Continuously lit up: On when the Heat Shift function
is activated.
7 Bridge indicator
Continuously lit up: On when the two zones are
bridged.
8 Timer setting touch key
Decrease/increase the kitchen timer duration.
9 Timer touch key
Press to set the kitchen timer.
4 5
8 7 6