Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STUFFER ASSEMBLY
WARNING! Before cleaning, assembling or disassembling the Grinder, make sure
it is turned "off" and disconnected from the power source. Test to make sure there is
no power to the Grinder by switching the Motor Unit "on" and "off."
1. Place the Plastic Washer then the Bushing Set onto the end of the Auger
opposite the Pin (FIGURE 3).
2. Carefully insert the Auger into the Grinder Head.
3. Place the Knife onto the square portion of the Auger Pin. The cutting edges of
the Knife should face outward (FIGURE 4).
4. Place the Course Grinder Plate onto the round portion of the Auger Pin. Align
the tabs on the Grinder Plate with the notches in the Grinder Head.
5. Insert the Stuffing Funnel through the Front Ring Nut (FIGURE 3).
6. Screw the Front Ring Nut/Stuffing Funnel assembly onto the Grinder Head
until firmly tight. DO NOT over-tighten the Front Ring Nut to avoid damaging the
Grinder during operation.
7. Loosen the Head Locking Knob on the side of the Motor Unit.
8. Install the Grinder Head onto the Motor Unit (FIGURE 3).
9. Tighten the Head Locking Knob to secure the Grinder Head.
10. Install the Tray onto the Grinder Head. Press the Tray down until fully seated
(FIGURE 3).
FIGURE 4
Knife
with
cutting
edges
facing
outward.
Stuffing
Funnel
Front
Grinding
Ring
Plate
Nut
Auger
Auger
Pin
Grinder
Bush-
Plastic
Head
ing Set
Washer
Stomper
Tray
Head
Locking
Knob
Motor
Unit
FIGURE 3
Reverse
Power
Button
Switch
9
Publicité
Table des Matières
