Lubrication - LGB 21426 Mode D'emploi

Multi-Train System
The model is equipped with a "DCC interface" to connect
a 3 amp decoder (Fig. 1). Remove the plug on the decoder
interface and connect the decoder. We recommend the LGB
55027 MTS Loco Decoder III. Its plug fits directly onto the
pins of the interface.
The power control switch does not work when a decoder is
installed.
SERVICE

Lubrication

The axle bearings should be lubricated occasionally with a
small amount of LGB Maintenance Oil (50019).
Replacing the light bulbs
Lanterns: Carefully pry the lens away from the lantern. Using
tweezers, remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the traction tire
• Use a small, straight-blade screwdriver to replace the
traction tire:
• Pry the old traction tire out of the wheel groove.
• Gently insert the new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the
wheel groove.
7