Scene Setup; Setting Zone Levels, Fade Rates, And Shade Group Actions - Lutron GRAFIK Eye QSGRJ-3P Guide Rapide D'installation

Scene Setup

Setting Zone Levels, Fade Rates, and Shade Group Actions

1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight "Scene setup" and press the
Timeclock
OK button to accept.
3. Use the Master buttons to highlight "Levels" to adjust lighting and/
Scene setup
or shade levels. Press the OK button to accept. Use the Master
buttons to highlight the scene number of your desired scene. Press
the OK button to accept.
Scene setup
4. Set each zone to the desired light level for this scene using the
Levels
zone raise/lower buttons. The info screen will display the zone and
percentage as you adjust it.
Labels
To set a zone as unaffected, lower the light levels all the way to
off, then hold the zone lower button for 3 seconds. The screen
will display "---" and the three middle LEDs for the zone will be lit
Scene setup
to indicate this zone is unaffected by the scene (the zone will not
change when this scene is initiated).
Scene 1
When all zones are at the desired level, press the OK button to
accept.
5. Use the Master buttons to set the fade time for this scene. Press
the OK button to accept.
Scene 1
6. Note: This step is applicable only if you have shades on your
Set zones
system. If you do not have or do not wish to set shade groups for
3 seconds this scene, press the OK button to skip this step.
Set each shade group to the desired level for this scene. When
all shade groups are at the desired level, press the OK button to
Scene 1 accept.
For shade programming, see the full installation and operation
Adjust fade
guide at www.lutron.com/qs.
seconds
3
7. The info screen will confirm that your scene has been saved.
8. Exit programming mode.
Scene 1
Set shade
Groups
Saved
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS Control Unit Quick Installation and Operation Guide
Master
buttons
OK
OK
button
Timeclock
(back) button
Shade
button group
Zone raise
Zone lower
13