Repairs; Diagnostics Messages - Teuco SEASIDE T07 Manuel De L'utilisateur

if any part of the appliance fails to operate as it should, call the nearest Teuco authorized Service Centre (see list
attached) .
The appliance is equipped with various safety features which monitor the operation of the system .
in the event of malfunction, a controller automatically deactivates the function currently in use .
The type of error detected is shown on the bottom line of the display .
Certain kinds of trouble can be rectified without calling in a technician; the following table indicates the action to take when
a function locks up .
TROUBLE OR FAULT
Waterlight prevented from starting up due to insuf-
aDD water
ficient water in tub .
Disinfection cycle prevented from starting due to
aDD
insufficient liquid in dispenser .
DiSiNFeCtaNt
Suction valve blocked .
lOw PreSSure
if the display indicates a fault other than those mentioned in the table, the system needs to be RESET as follows:
- isolate the appliance from the power supply
- reconnect power after a few seconds
- select the function which locked up previously .
if the fault persists, call the nearest Teuco authorized Service Centre (see list attached) .
SEASIDE SEASIDE

REPAIRS

DIAGNOSTICS MESSAGES

CAUSE
s
ACTION
Fill the tub with water to the minimum level allowing the
function to self-activate
Replenish the dispenser with liquid disinfectant supplied
by Teuco .
Clean the suction valve (see maintenance heading) .
EN
IT
25 25