Disinfection - Teuco SEASIDE T07 Manuel De L'utilisateur

EN
IT
When the system is switched off using the "O/i" button after at least one Waterlight or Blower cycle has been selected,
During Disinfection, both the remote control and the control panel are deactivated
DISINFECTION DOES NOT START!!!
22
22

DISINFECTION

a DiSiNFECTiON cycle will follow .
except for the "O/I" and "ALARM" buttons, which can be used to
suspend the Disinfection cycle at any given moment.
RUNNING ThE DISINFECTION CyCLE
Be sure to VACATE ThE BAThTUB before Disinfection
takes place.
press "ENTER" to start the Disinfection .
The display shows a warning message for a few seconds .
To postpone the disinfection cycle, press the "O/i" button
and the display will revert to STaND-By .
Thereafter,
The display indicates Disinfection in progress;
The disinfection cycle is automatic and includes the following
steps:
- pump operates for 1 minute approximately, with cleansing
fluid supplied from the dispenser;
- pause of 10 minutes allowing disinfectant action;
- suction valve closes .
When the Disinfection cycle has finished, the system shuts off
and the display reverts to STaND-By .
Turn the handle of the pop-up waste to empty the tub.
if the message "aDD WaTER" is displayed, fill the tub to the
level at which the Disinfection cycle is able to start .
S t a r t
D i S i N F e C t i O N ?
Display showing
Disinfection prompt
l e a V e
B a t h t u B
D i S i N F e C t i O N
r u N N i N g
2 0 : 3 0
Display in STAND-By mode
a D D
w a t e r
Display in
DIAGNOSTICS mode
SEASIDE
SEASIDE