Access To The Control; Condensate Outlet - Dantherm CDP 35T Manuel D'entretien

If the wall is between 130 and 350 mm thick, the center piece of the duct kit is shortened to the required length
before assembly.
The center piece of the duct kit – 235 mm Duct kit - 350 mm
When the duct kit has been installed in the duct openings, the unit is hung up on the rail.

2.3 Access to the control

Open the unit by removing the screws (4) on the front of the unit, i.e. opposite to the unit's duct openings. The
screws may be removed by means of the enclosed Allen key with hexagon head.
The control of the unit is located in a box on top of the compressor. To get access to the control you have to
unscrew the screws on the front of the box lid. Push the lid backwards and then pull it away from the box.

2.4 Condensate outlet

The condensate outlet is located at the base of the dehumidifier. The unit has a drain spigot intended for connection
of a ½'' flexible or fixed water hose.
It is important that the hose from the dehumidifier to the drainage has a fall of at least 2% to make sure that the
water runs away from the condensate tray.
As an alternative a condensate pump can be fitted at the water outlet to pump the water to a drain.
The placing of the condensate outlet is shown on the drawing below – the unit is seen from above.
12