Access To The Control; Connection Of Power Supply; Operation; Built In Hygrostat - Dantherm CDP 35 Manuel D'entretien

2.3 Access to the control

Remove the front panel by screwing off two screws on top of the dehumidifier. Lift the front panel vertically
upwards and then pull it horizontally away from the unit.
The control of the unit is located in a box on top of the compressor. To get access to the control you have to screw
off the screws on front of the box lid. Push the lid towards the rear of the dehumidifier and then pull it away from
the box.

3. Connection of power supply

Power is connected to the unit in accordance with the nameplate. Please refer to wiring diagrams on pages 31-33.

4. Operation

4.1 Built in hygrostat

The dehumidifier is controlled by a built-in hygrostat that is set to approx. 60% RH. When the hygrostat registers a
relative humidity of more than 60%RH, the compressor and the fan(s) automatically switch on and the
dehumidifier starts to dehumidify. The hygrostat is located next to the evaporator at the bottom of the compressor
housing.
If you want to set the hygrostat at a lower relative humidity than 60% the set screw has to be turned clockwise.
We recommend installing an external hygrostat if you want to change/adjust the setting of relative humidity very
often.

4.1.1 Connection of external hygrostat

Uncoupling the built-in hygrostat from the terminals 21/22, and then connecting the external hygrostat to these
terminals connect an external hygrostat. The hygrostat cable is led out through the bottom of the unit and the
hygrostat is then fixed to a wall in an appropriate place. The outlet for the external hygrostat is 12 V.
NOTE! All electrical connections must be made in
accordance with local power supply
company regulations.
NOTE! If the air humidity is below 60%RH, the
unit will not start when the power is
connected.
11