Safety Warnings Specific For Sanding Operations; Know Your Product; Operation; Prior To Initial Operation - SPARKY SM 717CE Notice Originale

Safety Warnings Specific for Sanding
Operations
а) Do not use excessively oversized sand-
ing disc paper. follow manufacturer's
recommendations, when selecting sand-
ing paper. Larger sanding paper extending
beyond the sanding pad presents a lacera-
tion hazard and may cause snagging, tear-
ing of the disc or kickback.
Safety Warnings Specific for Polishing
Operations
а) Do not allow any loose portion of the pol-
ishing bonnet or its attachment strings to
spin freely. Tuck away or trim any loose
attachment strings. Loose and spinning
attachment strings can entangle your fin-
gers or snag on the workpiece.
V - Know your product
Before using the power tool, familiarise your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Driving machine
2. Long arm
3. Sanding head
4. Front handle
5. Rear handle
6. Dust extraction port
7. Brush ring
8. Swing joint unit
9. Coupling opening
10. Flexible shaft
11. Outgoing spindle
12. Coupling journal
13. Spring
14. Body
15. Guard
16. Axis
17. C-clip
18. Flexible hose
19. Eccentric lever
20. Screw М6х10
21. Incoming ventilation slots
22. Outgoing ventilation slots
23. Clip
24. Clamp
25. Spindle
26. Flange
27. Set of pads
Original instructions
28. Tightening nut
29. Spindle lock button
30. Special spanner
31. Diamond disc
32. Centring element
33. ON/OFF switch slider
34. Distance washer
35. Flexible backing pad
36. Speed regulator
37. Sanding paper
38. Abrasive net
39. Polishing pad
40. Screw
41. Flexible backing pad
42. Distance pad
43. Tooth
44. Groove
45. Adjusting screw
VI - Operation
This power tool is supplied from single-phase al-
ternating current mains only. It is double insulat-
ed according to EN 60745-1 and IEC 60745 and
can be connected to grounded or not grounded
sockets. This power tool is radio suppressed in
compliance with EMC Directive 2004/108/EC.
The basic use of this power tool is for sand-
ing plaster coated ceilings and walls, for sand-
ing smoothed drywalls and for removing paint,
wallpaper and adhesive remnants by means of
sandpaper.
When using an appropriate tool (diamond disc,
polishing pad) the machine can be used for
sanding stone and concrete walls or for surface
polishing.
This power toll is not designed for CUTTING!
WARNING: Using this power tool with
accessories differing from the described here-
with may cause accidents during operation.
The possibility to connect an operating tool
does not mean the machine is designed to be
used with it.
Using this power tool with accessories differ-
ing from the described herewith and all risks
for your health resulting from such use are en-
tirely on YOUR OWN RESPONSIBILITY!

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name plate
with technical data of the tool.
7
EN