Belkin N1 VISION Mode D'emploi page 98

Troubleshooting
I can't connect to the Internet wirelessly, but my network name is listed.
If the name of your network is listed in the "Available Networks" list, please follow
the steps below to connect wirelessly:
1. Click on the correct network name in the "Available Networks" list.
2. If the network has security (encryption) enabled, you will need to enter the
network key. For more information regarding security, see the section entitled
"Changing the Wireless Security Settings".
3. Within a few seconds, the tray icon in the lower, left-hand corner of your screen
should turn green, indication of a successful connection to the network.
I can't connect to the Internet wirelessly, and my network name is not listed.
If the correct network name is not listed under "Available Networks" in the wireless
utility, please attempt the following troubleshooting steps:
1. Temporarily move computer, if possible, five to 10 feet from the N1 Vision.
Close the wireless utility, and reopen it. If the correct network name now
appears under "Available Networks", you may have a range or interference
problem. Please see the suggestions discussed in the section titled
"Placement of your N1 Vision" in this User Manual.
2. Using a computer that is connected to the N1 Vision via a network cable (as
opposed to wirelessly), ensure that "Broadcast SSID" is enabled. This setting
is found on the N1 Vision's wireless "Channel and SSID" configuration page.
If you are still unable to access the Internet after completing these steps, please
contact Belkin Technical Support.
96