Belkin N1 VISION Mode D'emploi page 83

Using the Web-Based
Advanced User Interface
Advanced Feature: The "Remote Access Port" option allows you to
configure the desired "Remote Access Port for Remote Management"
feature. The default access port is set to port 80.
Enabling/Disabling NAT (Network Address Translation)
Note: This advanced feature should be employed by advanced users only.
Before enabling this function, MAKE SURE YOU HAVE SET THE
ADMINISTRATOR PASSWORD. Network Address Translation (NAT) is the
method by which the N1 Vision shares the single IP address assigned by
your ISP with the other computers on your network. This function should
only be used if your ISP assigns you multiple IP addresses or you need
NAT disabled for an advanced system configuration. If you have a single IP
address and you turn NAT off, the computers on your network will not be
able to access the Internet. Other problems may also occur. Turning off NAT
will not affect your firewall functions.
81
1
2
3
4
5
6
7
8
9
10