Belkin N1 VISION Mode D'emploi page 100

Troubleshooting
I am having difficulty setting up Wired Equivalent
Privacy (WEP) security on my Belkin N1 Vision.
1. Log into your N1 Vision.
Open your web browser and type in the IP address of the N1
Vision. (The N1 Vision's default is 192.168.2.1.) Log into your N1 Vision
by clicking on the "Login" button in the top right-hand corner of the
screen. You will be asked to enter your password. If you never set a
password, leave the "Password" field blank and click "Submit".
Click the "Wireless" tab on the left of your screen. Select the
"Encryption" or "Security" tab to get to the security settings page.
2. Select "128-bit WEP" from the drop-down menu.
3. After selecting your WEP encryption mode, you can type in your hex
WEP key manually, or you can type in a passphrase in the "Passphrase"
field and click "Generate" to create a WEP key from the passphrase.
Click "Apply Changes" to finish. You must now set all of your clients to
match these settings. A hex (hexadecimal) key is a mixture of numbers
and letters from A-F and 0-9. For 128-bit WEP, you need to enter 26 hex
keys.
For example:
C3030FAF4BB2C3D44BC3D4E7E4 = 128-bit key
4. Click "Apply Changes" to finish. Encryption in the Wireless N1 Vision
is now set. Each of your computers on your wireless network will now
need to be configured with the same security settings.
WARNING: If you are configuring the N1 Vision from a computer with a
wireless client, you will need to ensure that security is turned on for this
wireless client. If this is not done, you will lose your wireless connection.
Note to Mac users: Original Apple AirPort products support 64-bit
encryption only. Apple AirPort 2 products can support 64-bit or 128-bit
encryption. Please check your Apple AirPort product to see which version
you are using. If you cannot configure your network with 128-bit encryption,
try 64-bit encryption.
98