Belkin N1 VISION Mode D'emploi page 89

Manually Configuring Network Settings
Manually Configuring Network Adapters in Windows 98SE or Me
1. Right-click on "My Network Neighborhood" and select "Properties" from
the drop-down menu.
2. Select "TCP/IP Settings" for your installed network adapter. You will see
the following window.
(1)
(2)
3. If "Specify an IP address" is selected, your N1 Vision will need to be set
up for a static IP connection type. Write the address information in the
table below. You will need to enter this information into the N1 Vision.
4. Write the IP address and subnet mask from the "IP Address" tab (3).
5. Click the "Gateway" tab (2). Write the gateway address down in the chart.
6. Click the "DNS
Configuration" tab (1).
Write the DNS address(es)
in the chart.
7. If not already selected, select "Obtain IP address automatically" on the
IP address tab. Click "OK".
(3)
87
1
2
3
4
5
6
7
8
9
10