Belkin N1 VISION Mode D'emploi page 94

Troubleshooting
• The Assistant software completed installation,
but my web browser doesn't work.
• I am unable to connect to the Internet. The "modem" icon on
my N1 Vision is blinking, and the "internet" icon is blinking.
If you cannot connect to the Internet, and the "modem" icon is blinking, and
the "internet" icon is blinking, the problem may be that your modem and N1
Vision are not connected properly.
1. Make sure the network cable between the modem and the N1 Vision
is connected. The cable should be connected at one end to the N1
Vision's "to Modem" port, and at the other end to the network port on
your modem.
2. Unplug the cable or DSL modem from its power source for three
minutes. After three minutes, plug the modem back into its power
source. This may force the modem to properly recognize the N1 Vision.
3. Unplug the power to your N1 Vision, wait 10 seconds, and then
reconnect the power. This will cause the N1 Vision to reattempt
communication with the modem. If the "modem" icon on the N1 Vision
is not lit after completing these steps, please contact Belkin Technical
Support.
4. Try shutting down and restarting your computer.
92