Before Using It The First Time - Toto NEOREST SE Mode D'emploi

Before using it for the first time
Turn on the hot and cold water valves connected to the function module.
ӿ The position of the shut off valves will vary depending upon site.
Please turn the shut off valves on and supply hot and cold water to the function module.
Hot water
Cold water Cold water
valve
Cold water pressure
29-108.75 psi (0.2-0.75MPa) flowing
Turn on the circuit breaker.
Remove the Supplementary Protector cover.
Turn on the power lever on the Supplementary Protector.
Replace the Supplementary Protector cover.
ӿ When there is no hot and cold water from the shower for cleaning the tub, open the inspec-
tion port (installed on site) that is located near the shower and check the water shut off valve.
13
Procedure for first-time use
Function module
To circuit breaker
Hot water valve
Supplementary
Protector cover
Water heater
(Not included with product)
Hot water
Supply temperature 140-158°F (60-70°C)
Water pressure 29-108.75 psi (0.2-0.75MPa)
flowing
Power lever
ON
OFF