Toto NEOREST SE Mode D'emploi page 21

Lowering the bath temperature (Cooling water)
This adds cold water to lower the temperature of the bath water.
Switch screens.
ӿ Turn this button off or check to see that it is

Please operate with the On/Off button set to on.

This won't work unless there is water in the tub. Put water in the tub. ► See page 17.
Turn the Lower button to on.
After about 10 seconds (but at most 20 seconds), cold water will flow
from the Fill-Tub outlet.
When the bath water has reached the desired temperature, turn off the
Lower button.
The water flow will stop after about 10 seconds.
ӿ When the horizontal gauge (about 26 gallons or about 100 L) on the screen reaches the end, it will
stop automatically.
Press

This won't work if the Lower button or the Higher button is on.
21
.