Güde 2600 PRO Mode D'emploi Original page 6

Introduction
To enjoy your new appliance as long as possible, please read
carefully the Operating Instructions and the attached safety
instructions before using it. Further, we recommend keeping
the Operating Instructions to recall the product features in the
future.
Within the continuous product development, we reserve
the right to make technical changes to improve it.
This document represents original Operating
Instructions.
Appliance description (pic. 1)
1. Compressed air connection
2. Handle
3. Tool fixture
4. Operating lever
Use as designated
The professional pneumatic sheet metal shears have
exclusively been designed for cutting sheet metal. The cut-out
tool enables to perform corrugated, circular, straight or curved
cuts of small diameters.
The appliance cannot be used for works other than for which
the appliance has been designed and that are specified in the
Operating Instructions.
Any other use will be considered a use in conflict with the
designation. The manufacturer will not be liable for any
consequential damage and injuries. Please be sure to know
that the appliance has not been designed for industrial
purposes.
Supply includes
Take the appliance out of the transport package and check
whether there are the following parts:
1 piece Pneumatic sheet metal shears
1 piece Compressed air connection
1 piece User Guide
Please contact your dealer if any parts are missing or are
damaged.
Technical specifications
Operating pressure:
Air consumption:
Idle speed:
Connecting thread:
Recommended hose cross-section: 10 mm
Cutting power
Steel:
Aluminium:
Noise:
Weight:
General safety instructions
Please read and follow all these instructions before putting
the appliance into operation.
Keep the safety instructions for future reference!
Familiarise with the setting and proper use of the appliance.
Never let the pneumatic appliance unattended.
Keep the appliance out of reach of children and unauthorised
persons.
Never point the air stream at people or animals.
6.3 bar
85-500 l per minute
-1
2,600 per min
¼"
1.2 mm
1.6 mm
L 87.5 dB
WA
1.1 kg
6
Never put the pneumatic appliance near physical openings as
this could lead to life-threatening injuries!
To prevent tripping, do not use unnecessarily long pneumatic
hoses.
Always use eye, ear and hand protection. Sharp edges of
sheet metal may cause cutting injuries.
Compressed air connection via quick-acting coupling
only.
The operating pressure must be set using a pressure
reducing valve.
Do not use oxygen or flammable gases as the source of
energy.
Disconnect the appliance from the source of
compressed air before removing any failure.
Original spare parts to be used only.
Never let the appliance run with no load at full idle
speed.
CAUTION: Do not exceed the maximum pressure of 6.3 bar.
If sealing is not applied to the pneumatic insert, wrap it using
a Teflon tape (pic. 2+3).
Caution! Getting caught by the rotating tool!
Marking
Product safety:
Product corresponds to
applicable EU standards
Prohibitions:
General prohibition
(in connection with another
icon)
Warning:
Warning/Caution
Commands:
Read the Operating
Instructions!
Wear safety gloves!
Environment protection:
Dispose waste professionally
so as not harm the
environment.
Warning against flying
items
Wear protective glasses
and ear protectors!
Packing cardboard material
may be delivered to
collecting centres for
recycling.