Coffee Brewing; Programming The Quantity Of Coffee - Saeco nina Bar Mode D'emploi

5

CoFFee BReWinG

Warning! During the coffee brewing, do not
remove the pressurized portafilter by manually
turning it clockwise. Danger of burns.
• during this operation, the buttons (15 - 16) may flash on
and off; this is to be considered as standard and not a
faulty operating mode.
• Before using the machine, make sure that the hot water/
steam knob (4) is closed and that there is enough water
in the tank.
• (Fig.3) - Press the ON/OFF button (2).
• Wait for the buttons (15 - 16) to be permanently on. The
machine is now ready for coffee brewing.
5.1 using ground coffee
• (Fig.7) - Insert the pin (13) into the pressurized portafilter
(10).
• (Fig.8A) - Insert the adapter (12) into the pressurized
portafilter (10), then insert the filter (11).
• (Fig. 11) - Insert the portafilter into the brew unit from the
bottom (6).
• (Fig.12) - turn the portafilter from left to right until it locks
in place.
• (Fig.14) - Preheat the pressurized portafilter by pressing
the button (15). Water will spill out of the pressurized
portafilter (this has to be done only for the first coffee).
• Water dispensing will stop automatically.
• (Fig.16) - remove the portafilter from the machine by
turning it to the left and pour out any water left. As the
machine is fitted with the special filter (11), there is no
need to change the filter to make one or two coffees.
• (Fig. 9A) - Add 1-1.5 measuring scoop for single coffee
and 2 measuring scoops for double coffee. Remove any
coffee residues from the rim of the filter.
• (Fig.11) - Insert the portafilter (10) into the brew unit from
the bottom (6).
• (Fig.12) - turn the portafilter from left to right until it locks
in place.
• (Fig.13) - Take 1 or 2 preheated cups and place them
under the pressurized portafilter. make sure that they are
correctly placed under the coffee dispensing holes.
• (Fig.14) - Press:
- The button (15) to brew 1 coffee
- The button (16) to brew 2 coffees.
• When the programmed quantity of coffee has been
obtained, brewing will stop automatically. Remove the
coffee cups. (Fig.15).
• (Fig.16) - Wait a few seconds after brewing, then remove
the pressurized portafilter and empty the remaining coffee
grounds.
note: if a small quantity of water remains in the
portafilter; this is absolutely normal and is due
to the portafilter features.
note for cleaning: keep the filter of the
pressurized portafilter clean by removing it from
its seat and washing it with drinking water (Fig.17). Wash
the adapter and the pin of the portafilter, then wash the
portafilter itself.
5.2 using Coffee Pods
• (Fig.10) - By using a coffee spoon, remove the ground
coffee filter (11) and the adapter (12) from the pressurized
portafilter (10).
• (Fig.7) - Remove the pin (13) from the pressurized
portafilter (10).
• (Fig.8B) - Insert the pod filter (14) into the pressurized
portafilter (10).
• (Fig.11) - Insert the portafilter into the brew unit from the
bottom (6).
• (Fig.12) - turn the portafilter from left to right until it locks
in place.
• (Fig.14) - Preheat the pressurized portafilter by pressing
the button (15). Water will spill out of the pressurized
portafilter (this has to be done only for the first coffee).
• Water dispensing will stop automatically.
• (Fig.16) - remove the pressurized portafilter from the
machine by turning it to the left and pour out any water
left.
• (Fig.9B) - Insert the pod into the portafilter and make sure
the paper of the pod does not overhang the portafilter.
• (Fig.11) - Insert the portafilter into the brew unit from the
bottom (6).
• (Fig.12) - turn the portafilter from left to right until it locks
in place.
• Take 1 preheated cup and place it under the portafilter;
make sure that it is correctly placed under the coffee
dispensing holes.
• (Fig. 14) - Press the button (15) for 1 coffee.
• When the programmed quantity of coffee has been
obtained, brewing will stop automatically. Remove the
coffee cups. (Fig.15).
• (Fig.16) - Wait a few seconds after brewing, then remove
the portafilter and dispose of the used pod.
note for cleaning: keep the filter of the
pressurized portafilter clean by removing it from
its seat and washing it with drinking water (Fig.17). then
wash the portafilter itself.
5.3

Programming the Quantity of Coffee

It is possible to preset the quantity of coffee to be brewed
by pressing the buttons (15) or (16).
the quantity of coffee can only be programmed
for the button (15) (min. 25cc, max. 180cc).
By pressing the button (16), you will have twice the
quantity programmed by the button (15).
• to start programming, insert coffee into the portafilter as
shown in Sections 5.1 and 5.2.
• Place a cup under the brew unit (10).
• (Fig. 14) - Press the coffee brew button (15) for a few
• 1 •