Saeco nina Bar Mode D'emploi page 21

Fault
The machine does not turn on.
The pump is very noisy.
all buttons are flashing.
The coffee is too cold.
Milk does not froth.
It is not possible to prepare a
cappuccino.
The coffee is dispensed too
fast, no foam builds up.
Coffee is not dispensed or
dispensed only in drips.
Coffee drips from the edges.
Please contact an authorized service centre for any faults not covered in the above table or when the suggested
solutions do not solve the problem.
Possible cause
Machine not connected to the power
supply.
Water tank empty.
Water circuit needs priming.
the portafilter is not inserted for
preheating (Section 5).
Cold cups.
Not suitable milk: powdered milk,
low-fat milk.
The cappuccinatore is dirty.
No steam in the boiler.
too little coffee in the portafilter.
Coffee ground is too coarse.
Coffee is old or not suitable.
Old or not suitable pod.
One component missing in the
portafilter.
No water.
the grind is too fine.
coffee pressed in the portafilter.
too much coffee in the portafilter.
Knob (4) is open.
Traces of limestone.
the filter in the portafilter is clogged.
Not suitable pod.
the portafilter is incorrectly inserted
into the brew unit.
the upper edge of the portafilter is
dirty.
The gasket of the boiler is dirty or
worn.
Pod wrongly inserted.
too much coffee in the portafilter.
solution
Connect the machine to the power supply.
refill with water (section 4.4).
Prime the circuit as described in Section
4.5.
Preheat the portafilter.
Preheat the cups with hot water.
Use whole milk.
Clean the cappuccinatore as described in
Section 9.
Prime the circuit (section 4.5) and repeat
the procedure described in Section 8.
Add coffee (Section 5).
Use a different blend (Section 6).
Use a different blend (Section 6).
Change the pod.
Make sure that all components are present
and that they have been installed properly.
refill with water. (section 4.4).
Use a different blend (Section 6).
Shake the ground coffee.
Reduce the quantity of coffee in the
portafilter.
Close the knob (4).
Descale the machine (section 10).
clean the filter (section 9).
Change type of pod.
Insert the portafilter correctly (section 5).
clean the rim of the portafilter.
Clean the gasket.
Insert the pod correctly. Make sure it does
not come out of the portafilter.
Reduce the quantity of coffee using the
measuring scoop.
• 1 •