Brewing Coffee; Coffee Preparation - Saeco Tchibo Cafissimo Mode D'emploi

Masquer les pouces Voir aussi pour Tchibo Cafissimo:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• 18 •
Follow the instructions below to use your desired cup:
Espresso cup
or caffè crema cup
Drip tray in the top position.
Filter coffee cup
: Drip tray in the
bottom position.
Latte macchiato glass: Completely remove
the drip tray and place the glass directly on
the machine base underneath the drip tray.
Espresso
Caffè crema
Filter coffee

BREWING COFFEE

Coffee preparation

1- Turn on the machine by pressing the ON/OFF
flashing button shows that the machine is in the heating phase.
Before brewing a coffee, check that the On/Off button
and beverage buttons are constantly lit and that
there is enough water in the tank.
Never insert fingers or any other objects into the
capsule compartment. Single-portion capsules brew
a single coffee. Do NOT use capsules more than once. When
preparing an espresso or caffè crema, the machine performs
a pre-brewing cycle. There is an audible pause in the brewing
process between the pre-brewing and brewing cycles.
:
(white) = "black capsule"
(yellow) = ''yellow capsule''
(blue) = "blue capsule"
We recommend emptying the used capsule drawer
and waste water drawer daily. Before inserting a
capsule, make sure that the used capsule drawer is not full.
If the machine has not been used for a long time, or
if the coffee cup is cold, we suggest placing the cup
underneath the spout and pressing the espresso button
without using a capsule. The cup will be filled with hot water.
This will heat the machine and the cup.
After that, empty the cup and follow the steps below.
1- Place a small or large cup underneath the coffee dispensing
spout as indicated in the paragraph "Adjusting the dispensing
height".
2- Lift the capsule compartment opening lever (Fig. 1).
3- Insert a capsule as illustrated (Fig. 2).
4- Lower the lever to close the capsule compartment (Fig. 3).
Fig. 1
If the compartment does not close easily, check that
the capsule is correctly inserted and that the used
capsule drawer is not full.
5- Press the
button for a caffè crema or the
coffee.
6- The coffee brewing process stops automatically when the preset
level is reached. However, you can stop dispensing earlier by
pressing the same button another time.
7- Lift the lever to eject the used capsule into the used capsule
drawer.
button. The
8- Enjoy your freshly brewed coffee.
With every coffee brewed, a small amount of excess
water is dispensed into the drip tray. Therefore,
empty the drip tray regularly.
If the machine stops during the brewing process and
the service indicator light slowly flashes orange,
there is no more water in the water tank. Proceed as follows:
Fill the tank with water and push the button of the drink that
was being dispensed. As soon as the desired quantity has been
reached, stop dispensing by pressing the beverage button
again.
Fig. 2
(white) button for an espresso, the
(blue) button for a filter
Fig. 3
(yellow)

Publicité

Table des Matières
loading

Table des Matières