Placing And Leveling The Range - Thermador Pro Harmony PRD304WHC Instructions

To reinstall the oven door
1. Hold the door firmly in both hands.
2. Hold the door at a 30° angle from the closed position.
Insert hinges centered evenly into the hinge slots. The
hinges will securely hook into the slots when properly
installed. DO NOT force, bend or twist the door.
3. Open door fully to expose hinges, levers, and slots.
4. Flip the hinge until seated on the bracket. A
screwdriver may be required to carefully push the clip.
5. Close and open the door slowly to ensure it is
correctly and securely in place.
To check door fit and adjustment
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. DO NOT
force the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "Placing and leveling the range".
3. Verify that the hinges are properly seated into the
hinge slots, and that the hinge clips are fully engaged
into the slots.
Page. 21
If door or handle appears slightly tilted
4. Rotate the large Torx head screw located directly
above the hinge receiver with a T-30 Torx driver.
Rotate each screw respective to its side and direction
the door needs to be adjusted.

Placing and leveling the range

9 CAUTION
The top edges of the range's side panels must be on
the same or higher level as the adjacent countertop.
DO NOT operate range if sides are lower than the
adjacent cabinet. If the range is operated while at a
lower height relative to the adjacent cabinet, the
cabinet could be exposed to excessive temperatures,
causing damage to the cabinet and countertop.
Leveling leg adjustment
For proper performance, the range must be level. Priority
should be placed on ensuring that the oven cavities are
also level for optimum cooking performance.
1. Measure the countertop heights first with a tape
measure and add an additional 1/16'' - 1/8'' (2-3 mm).
2. Rotate the legs using a 12'' (305 mm) adjustable
wrench on the flat sides of each foot.
• Leveling legs should be adjusted so that the range
sides are at the same or higher level as the
adjacent cabinet. Adjust the legs accordingly prior
to pushing the range back to its final location.