Placing And Leveling The Range - Thermador Professional Serie Mode D'emploi

2. Rotate the warming drawer door out and then pull
down to disengage from the retainer tabs.

Placing and leveling the range

9 CAUTION
The top edges of the range's side panels must be on the
same or higher level as the adjacent countertop. DO NOT
operate range if sides are lower than the adjacent cabinet.
If the range is operated while at a lower height relative to
the adjacent cabinet, the cabinet could be exposed to
excessive temperatures, causing damage to the cabinet
and countertop.
Leveling leg adjustment
For proper performance, the range must be level. Priority
should be placed on ensuring that the oven cavities are
also level for optimum cooking performance.
1. Measure the countertop heights first with a tape
measure and add an additional 1/16'' - 1/8'' (2-3 mm).
2. Rotate the legs using a 12'' (305 mm) adjustable
wrench on the flat sides of each foot.
3. Leveling legs should be adjusted so that the range
sides are at the same or higher level as the adjacent
cabinet. Adjust the legs accordingly prior to pushing
the range back to its final location.
• It may be necessary to reposition the gas supply
line and the electrical cord as the range is pushed
back to its final position. This may be
accomplished by carefully pulling on a rope or
twine looped around the gas or electrical supply
line as the range is pushed back into its final
installed position.
4. As the range is moved into its final, installed position,
verify that the anti-tip bracket is in a position to
engage the range.
19
1
2
To level 60'' models
1. Height adjustments of the two rear caster legs are
made by turning the 5/16'' socket located behind the
front frame.
• Rotation direction will vary depending on which
side of the appliance is being adjusted.
• The oven doors must be removed in order to
access the leveling socket for the rear wheels (see
"Door removal and adjustment"). On models with
a warming drawer, the socket for the left caster
may be accessed by pulling the warming drawer
open.
2. With the range in the installed position, the final
height adjustments are made to the two front legs to
ensure proper alignment to the counter top.
3. Lower the center leveling foot of the unit to help
support the appliance weight.
Adjusting the kick panel, Pro Harmony models
1. Remove the kick panel screws using a T-20 star-head
screwdriver.
2. Relocate kick panel at one of the five screw hole
positions, as noted below. Reinstall the star-head
screw.