Level Adjustment - Jacuzzi ERA FREESTANDING Serie Instructions D'installation Et Fonctionnement

Step 2
X
X
Place the Slipper bathtub in the pre-determined permanent location.
X
Y
Using a pencil, mark on the ground where the notch cutout is on the
inside of each claw foot (Figure 3). This will be where the mounting hole
will be drilled in the floor. Repeat this step for the remaining locations.
X
Z
With the help of an assistant, gently lift the Slipper bathtub and place it
to the side.
Step 3
X
X
At each marked location, drill a
X
Y
Repeat this step for the remaining locations.
X
Z
When complete, clean the drilled hole of all debris.
X
[
Insert the anchor into the drilled hole. If necessary, use a hammer and
gently tap the anchor into place until it is level with the floor.
X
\
Thread the shaft into the anchor. If needed, a screwdriver maybe used.
Leave ⅜" of the shaft exposed (Figure 4).
X
]
Repeat the previous two steps for the remaining locations.
Step 4
It is strongly recommended that two people perform the following
steps.
X
X
Lift the Slipper bathtub, with legs attached.
X
Y
Slowly lower the unit down onto the ground, making sure that the
shafts and notch cutouts align properly (Figure 5).

Level Adjustment

Use of a level will be needed to verify that the bathtub is level. If the
bathtub is not level, please perform the following steps.
To level the bathtub:
X
X
Use an Allen wrench (supplied) and loosen the level adjustment
bolts (Figure 6).
X
Y
Adjust the bathtub to the desired levelness.
X
Z
Retighten the level adjustment bolts.
Tighten
Once the bath tub has been secured, all finish plumbing must be
installed. Please refer to the installation instructions that are included in
the packaging.
When complete, please proceed to the "Leak Test" section.
Page 8
" hole 1½" in depth.
7
16
Loosen
www.jacuzzi.com
Era™ Freestanding Bath
Figure 3. Mounting Hole Mark
Figure 4. Drilling Hole Mark
⅜"
Figure 5. Anchoring the Slipper Bathtub
DOWN
UP
Figure 6. Level Adjustment
Installation and Operation
Pencil
Notch Cutout
Shaft
Anchor
Notch Cutout
Shaft
Level Adjustment
Bolts
Level Adjustment
Bolts