Jacuzzi ERA FREESTANDING Serie Instructions D'installation Et Fonctionnement page 15

Era™ Freestanding Bath Era™ Freestanding Bath
Installation
Step 1
X
X
Center the opening on the pedestal base with the drain opening
(Figure 26).
Step 2
X
X
Gently place the bathtub in the base.
X
Y
Make any necessary adjustments at this time. The bathtub must sit
evenly in the base.
X
Z
Using a pencil, outline the pedestal base, taking note where the
drain access is located (Figure 27).
X
[
Remove the bathtub.
It may be necessary to adjust the pedestal legs to be level for the
bathtub to fit properly in the base. Do that now, if necessary.
Step 3
Make sure the overflow opening on the bathtub and the drain
access on the base are on the same side before permanently
marking the mounting location.
X
X
Remove the pedestal base. Place the bathtub back in the
determined location. Make sure the overflow opening on the bathtub
is centered on the drain (Figure 28).
X
Y
Using a pencil, lightly outline the pedestal leg. Repeat this step for
the remaining three (3) pedestal legs.
Step 4
X
X
At each marked location, drill a
Repeat this step for the remaining locations.
X
Y
When complete, clean the drilled hole of all debris.
Step 5
X
X
Insert the wedge anchor into the drilled hole. If necessary, use a
hammer and gently tap the wedge anchor into place (Figure 30).
X
Y
Use a wrench to tighten the nut. Do not overtighten this nut. Tighten
the nut until it is firmly secured.
X
Z
Repeat the previous two steps for the remaining locations.
Installation and Operation
" hole 1½" in depth (Figure 29).
7
16
www.jacuzzi.com
Figure 26. Pedestal Base Placement
Figure 27. Bathtub Placement
Figure 28. Pedestal Leg Attachment
Center
Point
1½"
Figure 29. Drilling the Mounting Hole
Figure 30. Wedge Anchor Installation
Water Supply Lines
Bathtub
Base
Pencil
Drain
Access
Bathtub
Pedestal
Leg
Pencil
7 " Drill Bit
16
Nut
Wedge
Anchor
Page 15