Securing The Unit - Jacuzzi ERA FREESTANDING Serie Instructions D'installation Et Fonctionnement

Era™ Freestanding Bath Era™ Freestanding Bath

Securing the Unit

It is strongly recommended that two people perform
the following steps.
Step 1
X
X
Center the bathtub with the drain line that is located
on the floor.
X
Y
Measure 6" from the center of the water supply line
to the center of the bathtub drain opening
(Figure 19).
These measurements will remain the same if you
decide to install the bathtub length-wise.
Step 2
X
X
Using a pencil, lightly outline each support leg. Remove the bathtub
(Figure 20).
X
Y
Use a tape measure to determine the center of the square outline.
Mark this location. Repeat this step for the remaining three support
legs.
X
Z
Use a tape measure to verify the following measurements:
Large Frame - 26 ⅞" (W) x 39" (L)
Small Frame - 24 ⅜" (W) x 33" (L)
Step 3
X
X
At each marked location, drill a
Repeat this step for the remaining locations.
X
Y
When complete, clean the drilled hole of all debris.
Step 4
X
X
Insert the wedge anchor into the drilled hole. If necessary, use a
hammer and gently tap the wedge anchor into place (Figure 22).
X
Y
Use a wrench to tighten the nut. Do not overtighten this nut. Tighten
the nut until it is firmly secured.
X
Z
Repeat the previous two steps for the remaining locations.
Installation and Operation
Center
Point
" hole 1½" in depth (Figure 21).
7
16
www.jacuzzi.com
39"
26⅞"
Drain
6"
Water Supply
33"
24⅜"
Drain
6"
Water Supply
Figure 19. Securing the Bathtub
Figure 20. Marking the Location
7
1½"
Figure 21. Drilling the Mounting Hole
Figure 22. Wedge Anchor Installation
Outline
" Drill Bit
16
Nut
Wedge
Anchor
Page 13