Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Software
Operation
Connection Tab
Connection Tab Options
Button
Serial
Ethernet
Screenshot of
Connection Tab
VIP™ 5162 Signal Processor User Manual Rev. 1
The software is an intuitive user interface for configuring and operating the signal processor. A three
tab format presents options for connection, configuration, and operation. A menu across the top
presents options for advanced configurations.
This Software Operation section covers the following topics.
·
Connection tab
for connecting to the signal processor.
·
Mode Tab
for operating the signal processor.
·
Config tab
·
Menu options
Have the software available when using this section.
The connection tab is the firsat tab to use. It connects the software to the signal processor.
Pull Down
Options
Sets serial interface as the mode to connect to the signal processor.
COM0–
CommPort
COM4
9600/19200/
BaudRate
38400/57600/115200
Sets LAN Ethernet as the mode to connect to the signal processor.
Local Port
0–9999
Remote Host
xxx.xxx.x.xxx
Remote Port
0–9999
Open Comm
Refresh
Sets the COMM port for the serial device.
Sets the baud rate for the serial connection.
Sets the IP port of the PC. Leave it at 1000.
Sets the IP address of the signal processor. Can be auto-populated
by clicking on the <REFRESH> icon. Can be manually populated
with the IP address found in the Signal Processor. See INF.
Sets the IP port of the signal processor. Leave it at 1000.
Connects the signal processor to the software.
Populates the Remote Host drop down menu with the IP address of
the signal processor.
Refresh
Open
Comm
4. Operation | Software Operation
Description
Page 31 of 140
Publicité
Table des Matières
