Setup; Mounting; Orientation; Rack Mounting - Chauvet VIP 5162 Signal Processor Mode D'emploi

3. S
ETUP

Mounting

Orientation

Rack Mounting

Mounting
Diagram
Front Panel
View
LCD Screen
Front Panel
Buttons
Page 14 of 140
Before mounting the signal processor, read and follow the safety recommendations in the
section.
The signal processor should be mounted horizontal to the ground, with the words and logo right-side
up. It is designed for installation into a rack, but can be placed on a table. The installation or placement
must allow adequate ventilation for the signal processor and provide access for the operator.
· Be sure to locate the rack and the signal processor so that there is easy access for maintenance
and programming and enough space around the signal processor for ventilation.
· Be sure to use 4 screws for mounting the signal processor into the rack.
· The 4 rack mounting holes in the front panel are big enough for size M6 screws.
Program Buttons
Menu Preview Buttons
Navigation (preview output)
Buttons
The front panel buttons provide access to all the configuration options and operational functions of
the signal processor. They are grouped for easy access with the menu navigation buttons near the
screen, the operational functions in the center, and the configuration options to the right.
The sections below describe the function of each button. The buttons are grouped the same way
they are labeled in the diagram above and they are listed in order from left to right and top to bottom
within their group.
Rack Mounting Holes
(live output)
Switching
Buttons
Menu
Effect
Function
Buttons
VIP™ 5162 Signal Processor User Manual Rev. 1
3. Setup | Mounting
Safety Notes
USB
USB
Port 2
Port 1