Remote Control Installation - brondell Swash CL825 Serie Manuel De L'utilisateur

Siège de toilette bidet avancée
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRODUCT INSTALLATION (cont.)

REMOTE CONTROL INSTALLATION

1. Battery Installation*
a. Separate the remote control from the magnetic wall mount by pulling apart gently.
b. Turn remote over and open the battery compartment by popping off the battery cover
with your finger or small coin. Insert three "AAA" type batteries (included) as indicated
inside battery compartment and replace battery cover.
c. To confirm the batteries are installed correctly, press the "Stop" button and you should
see the "Wide Spray" LED light turn on for a few seconds (note: the 2 other LED lights
may or may not turn on at this time depending on the current settings).
2. Mount Remote (optional)
a. Identify a location in the bathroom for the remote
control that is visible and reachable from the toilet.
b. Depending on the wall type, you can install using
the supplied screws and anchor mounts or use
the provided double stick tape on the back of the
remote wall mount.
Make sure the remote mount is fully secure with
either method so that it does not fall and damage
the remote control.
c. Place the remote control into the mount as shown.
*Important Battery Information:
1. Always purchase the correct size and grade of battery most suitable for the intended use.
2. Clean the battery contacts and also those of the device prior to battery installation.
3. Remove batteries from equipment which is not to be used for an extended period of time.
4. Remove batteries if consumed or if product is to be left unused for a long time.
14
Step 2c

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1018505Swash cl825-ew

Table des Matières