Using The Swash - brondell Swash CL825 Serie Manuel De L'utilisateur

OPERATING THE SWASH (cont.)

USING THE SWASH

Notes: The wash functions will not work unless the sensor in the seat detects someone
sitting down (skin conductivity sensor). To override the seat sensor, please refer to
the section in the manual called "Configuring a Special Mode".
The remote control will not operate the Swash if the batteries are weak, dead,
or not installed properly (remote requires 3 x AAA batteries to function).
Warm Aerated Water Wash
1. Sit on the seat and press the FRONT or REAR button on the remote to begin water flow. The
nozzles will self-clean and purge a small amount of water which will last for several seconds
prior to starting the wash function. The front or rear wand will then extend and wash for 2
minutes, then turn off automatically.
2. To keep the wash continuing longer than 2 minutes, press the FRONT or REAR button again
during the cleansing cycle. Each time your press the button during the cleansing cycle, the
2 minute cycle starts again.
3. If you would like to stop the wash before the 2 minute cycle ends, press STOP button to
discontinue flow.
4. While cleansing, users can adjust the water temperature, water pressure, spray width, and
nozzle position according to their preferences.
5. After the cleansing cycle, the nozzles will perform a self clean cycle purging water for
approximately 5 seconds.
Note: You cannot increase the water pressure level to higher than level 2 under the
following conditions: Main water supply temperature is under 10° C / 50° F or
if the rated power source is under 110V.
Nozzle Positioning
While the cleansing function is operating, use the Nozzle Position up and down arrows on the
remote control to move the position of the nozzles and spray.
18