BEFORE INSTALLATION
CHECK WATER SUPPLY LINE
Check the line that connects the toilet tank to the water shut off valve. If it is a rigid pipe, you
may need to purchase a flexible hose to replace it before installing the Swash. The length of
the hose and the size of the connectors will vary.
RESIDUAL MOISTURE IS NORMAL
Every product is tested with pure water during production to ensure the highest quality and
performance. It is normal to find a small amount of residual moisture on the product and in the
reservoir and filter.
TOOLS
A Phillips head or standard screwdriver may be needed to remove the existing toilet seat and
a standard wrench may be needed for tight water supply connections.
SWASH INSTALLATION
Please read these instructions carefully before installing the Swash. Failure to do so could
result in flooding, leaking or damage to the product.
1. Existing Toilet Seat Removal
a. Lift hinge covers and use a screwdriver to remove the mounting bolts.
b. Remove the toilet seat.
Note: Steps may vary by type of seat and toilet
2. Turn Off Water Supply Valve and Flush Toilet
a. Turn water valve off to stop the flow of water.
b. Flush toilet and hold down handle to completely
empty tank.
c. Disconnect water supply hose from toilet tank.
Notes: You may wish to place a container under the
tank to catch any excess water.
Do not continue without completing the
above steps. Failure to do so could result in
flooding, leaking or damage to the Swash.
Step 2c
11