brondell Swash CL825 Serie Manuel De L'utilisateur page 29

Problem
Water leaks from 1. Water leaking from the T-valve
areas other than the
nozzles
2. Water leaking from the bidet hose
connection
3. Water leaking from under the seat
4. Water leaking from behind the seat
Possible Cause(s) Solution(s)
1. Make sure that the rubber gasket is in-
serted correctly into the T-valve (flat side
down with lip pointing up towards the
toilet tank connection) and firmly tighten
the connector
2. Make sure that the bidet hose is
correctly connected and tight. Check any
rubber washers and do not over tighten
3. Check if there is anything between the
mesh filter and bidet. Remove, clean,
and reinstall mesh filter. Check if the filter
is damaged (see maintenance section)
4. Check the water tank plug in the back
of the seat (see maintenance section
under product storage and use)
27