Maintenance; Seat Cleaning & Removal; Nozzle Cleaning - brondell Swash CL825 Serie Manuel De L'utilisateur

MAINTENANCE

SEAT CLEANING & REMOVAL
Unplug the Swash from the power source before cleaning or removing the seat.
Use a soft, damp cloth and mild cleanser (such as dish soap, Simple Green or Windex) to wipe
down the seat. DO NOT scrub or use harsh, abrasive products to clean the Swash. DO NOT
use thinner, benzene, acidic chemicals, chloride, or hydrochloric acid detergent. This may
result in corrosion to the metal parts or discoloration or scratches to the bidet body.
For a more thorough cleaning, you may remove the Swash. To remove the seat, press the
Quick Release button on the left side of the Swash (slightly below & behind the Bidet Hose
inlet on the seat) and slide the seat forward off of the mounting plate and toilet.

NOZZLE CLEANING

1. Press the Nozzle Cleaning button on the Auxiliary
Control panel on the side of the Swash. The front wash
nozzle will fully extend. Gently clean the nozzle with a
soft cloth or toothbrush.
2. Press Nozzle Cleaning button again and the front
wash nozzle will retract and rear wash nozzle will fully
extend. Gently clean the nozzle with a soft cloth or
toothbrush.
3. Press Nozzle Cleaning button a third time and the rear
nozzle will retract back into the seat. Take care when
cleaning the nozzles not to apply too much pressure to
avoid damaging the nozzle system.
Step 1
23