Installation - brondell FreshSpa Warm FSW-20 Guide D'utilisation

Installation

Check the size of the connection at your water supply shut off
valve near your toilet and your hot water line (most likely under
the sink/wash basin) . They both need to be 3/8" connectors
for our T-valve to install . Note: if either connection is a ½"
connection, you will need to purchase the following reducing
adapter available online and at many plumbing hardware stores:
Reducing Adapter, ½" Female NPT X 3/8" Male Compression.
Check the water supply line that connects the toilet tank to the
water shut off valve at the wall . If it is a rigid pipe, you will need
to purchase a flexible water supply hose to replace it before
installing the FreshSpa . The length of the hose will vary, the
top connection size should be 7/8" ballcock to connect to your
fill valve under the toilet tank and the bottom connection size
should be 3/8" female compression to connect to the FreshSpa
brass T-valve .
1) Remove Existing Toilet Seat
a. Lift hinge covers and use flathead or Phillips head screwdriver
to remove the mounting bolts . Alternatively, you may need to
loosen mounting bolts underneath the seat .
b. Remove the toilet seat and set the seat, mounting bolts and
hardware aside .
5