brondell Swash CL825 Serie Manuel De L'utilisateur page 28

TROUBLESHOOTING (cont.)
Problem
Nozzles do not
function properly
Seat is not heated
Bidet wash feature
does not work or
fails to spray
Water (wash spray)
not heated
Water flows before or
after use
26
Possible Cause(s)
1. Nozzles are dirty
2. Clogged filter
3. Water pressure is too low
4. External bidet filter
1. Seat temperature set to off
2. Resettable fuse blown
1. Body sensor does not detect that you
are sitting on the Swash
1. Water temperature set to off
2. Resettable fuse blown
1. Water coming from nozzles
Solution(s)
1. Clean nozzles (see maintenance
section)
2. Remove, clean, and reinstall mesh filter
(see maintenance section)
3. Check water supply valve at wall to
fully open
4. If you have an external bidet filter,
check and replace if necessary
1. Make sure that the Seat temperature set-
ting is on (Low- Blue light, Med- Pink light,
High- Red light, Off- No light)
2. The bimetal resettable fuse may blow if
the temperature exceeds over the normal
level. The bidet will not work and show an
error message until the bidet cools down.
The fuse will automatically reset
1a. Adjust sitting position to fully cover
the Body Sensor (see page 9).
1b. Override the body sensor – refer to
Special Mode Operation section on page
21 to unlock the body seat sensor.
1. Make sure that the Water temperature
setting is on (Low- Blue light, Med- Pink
light, High- Red light, Off- No light)
2. The bimetal resettable fuse may blow if
the temperature exceeds over the normal
level. The bidet will not work and show
an error message until the bidet cools
down. The fuse will automatically reset.
1a. The water that comes out between
the nozzles before or after a wash
cycle is the self-clean cycle and is not a
malfunction
1b. Residual water may drip into the
bowl for several seconds after a wash
cycle, self-clean cycle, or nozzle
sterilization cycle and is not a
malfunction.