Installing The Appliance - Wall Mount - Napoleon NEFV38H Instructions D'installation Et D'opération

3.2

INSTALLING THE APPLIANCE - WALL MOUNT

A. Select a location that is not prone to moisture and is located at least 36"
(914mm) away from combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
B. Before installing the appliance, remove the front glass. Remove the
bottom screws off the appliance. Tilt the glass front and slightly pull down.
Remove and place on a soft non-abrasive surface, refer to Figure 2.
C. Have two people hold the appliance against the wall to determine the
fi nal location.
D. Mark out 5 drill hole locations, refer to Figure 1.
E. Using a 6mm drill bit, drill the 5 holes marked on the wall and fi t with
the supplied wall plugs, have at least one screw in a wall stud. NOTE:
If hole locations are on studs, you do not need to drill or use wall
plugs, simply apply screws directly into studs.
F. Lift the appliance onto the wall, align with the 5 pre-drilled holes.
Secure the appliance to the wall, refer to Figure 3.
G. Sprinkle the crystal embers along the ember bed, refer to Figure 4.
H. Install the glass front onto the appliance and secure with the two
screws from Step B.
I. Check the appliance for stability ensuring it will not pull free from the wall.
FIG. 2
SIDE VIEW
GLASS FRONT
FIG. 3
2 SCREWS
FIG. 1
6" [152mm]
3 TOP
SCREWS
FIG. 4
2 BOTTOM
SCREWS
9
6" [152mm]
EN
11" [279mm]
W415-1352 / 08.19.14