Napoleon ALLURAVISION Serie Manuel D'installation Et D'utilisation page 16

F
J
installation
I
U
EN
R
N
E
C
1. Remove the securing screw from the electrical cover plate located on the rear left side of the appliance.
P
T
2. Loosen the securing screw from the terminal block to remove the cord from the terminal block.
L
I
3. Add an electrical box connector and feed the supply wires through the 7/8" (22mm) hole from the terminal
A
O
block. C
N
E
4. Insert White (N) wire from power supply to the designated (N) slots in the terminal block. Secure by tightening
the screws on the (N) slots.
5. Repeat step 4 with Black (L1) and Green (G) to their designated slots in the terminal block.
6. Re-install cover plate.
F
J
I
U
R
N
E
C
P
T
L
I
A
O
C
N
E
4.6 240V hard wiring installation (NEFL32/42/50/60/74/100CHD only)
WARNING
!
• Turn off the appliance completely and let cool before servicing. Only a qualifi ed service person should service
and repair this electric appliance.
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection and wire the
appliance directly to the household wiring. The wire and double-pole power supply breaker must be rated for
240V minimum 15 amps, maximum 20 amps.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired,
in the absence of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the current
ANSI/NFPA 70 National Electrical Code in the United States.
note:
There are 6 wires from the appliance junction; white (neutral), 2 yellow (heater & neutral), black (power L1),
red (power L2), and green (ground) that connect to 240V power supply (breaker panel).
16
W415-2212 / 08.22.17
YELLOW (N1)
(L1)
BLACK
RED (L2)
WHITE (N)
GREEN (G)
WIRE NUT
WHITE (N)
BLACK (L1)
GREEN (G)
240V
S
P
BLACK (L1)
U
O
P
RED (L2)
W
P
E
L
R
WHITE
(N)
Y
(G)
GREEN
120V
S
P
WHITE (N)
U
O
P
W
P
E
L
BLACK (L1) R
Y
GREEN (G)
F
J
I
U
R
RED MARRET
N
E
C
P
T
L RED
I
A
O
C
N
E
GREEN
BLACK
WALL