Napoleon ALLURAVISION Serie Manuel D'installation Et D'utilisation page 17

White, black, red, and
green wires:
Connect to 240V
power supply.
1. Remove the securing screw from the electrical cover plate located on the rear left side of the appliance.
2. Loosen the securing screw from the terminal block to remove the cord from the terminal block. NOTE:
REMOVE 2 WIRE JUMPERS IN THE TERMINAL BLOCK.
3. Add an electrical box connector and feed the supply wires through the 7/8" (22mm) hole from the terminal
block.
4. Insert White (N) wire from power supply to the designated (N) slots in the terminal block. Secure by tightening
the screws on the (N) slots.
5. Repeat step 4 with Black (L1), Red (L2) and Green (G) to their designated slots in the terminal block.
6. Re-install cover plate.
F
J
I
U
R
N
E
C
P
T
L
I
A
O
C
N
E
note:
Leave enough wire so that the appliance can be removed from the enclosure without disconnecting the
F
J
power supply.
I
U
R
N
E
C
P
T
L
I
A
O
C
N
E
WHITE (N)
YELLOW (N1)
YELLOW (N2)
BLACK (L1)
RED (L2)
GREEN (G)
BLACK (L1)
RED (L2)
WHITE (N)
GREEN (G)
WIRE NUT
(N)
WHITE (N)
YELLOW (N1)
YELLOW (N2)
(L1)
BLACK (L1)
(L2)
RED (L2)
(G)
GREEN (G)
240V
WHITE (N)
P
O
W
BLACK (L1)
E
RED (L2) R
GREEN (G)
120V
P
(L1)
BLACK
O
W
E
R
WHITE (N)
GREEN (G)
installation
EN
S
U
P
P
L
Y
S
U
P
17
P
W415-2212 / 08.22.17
L
Y