Recessing The Appliance Into The Wall - Napoleon ALLURAVISION Serie Manuel D'installation Et D'utilisation

installation
EN
4.4

recessing the appliance into the wall

Due to the many different materials used on different walls, it is highly recommended that you consult your local
builder before you install this appliance on the wall.
Select a location that is not prone to moisture and is located at least 36" (91.4cm) away from combustible
materials such curtain drapes, furniture, bedding, paper etc.
1. Measure the appliance and create a rough in with electrical. The electrical junction box is located on the left
side of the appliance.
2. Remove the front glass, refer to "front glass removal" section.
3. Remove the plastic panel holders by removing the screws (Figure 1 & 2).
4. If side covers are installed prior to recessed installation, remove the side covers by removing the screws
(Figure 3 &4).
5. Install trims. See section Trim and Side Panel Installation.
6. Hold the appliance up to ensure it will fit into the framing (Refer to framing section for framing).
7. Use 4 screws to secure the unit into the wall (Figure 5).
8. Re-install the plastic panel holders.
9. Place the drift wood logs and topaz glass chips or crystals along the media tray, refer to " drift wood logs and
topaz glass chips installation" section.
10. Install front glass.
note:
Two sets of holes are provided for recessing into the wall. The wall structure may limit how far the appliance
can be recessed. Use the appropriate set of holes when recessing to the frame. It may be necessary to use
the four holes on the top and bottom.
note:
It is recommended that the walls of the appliance enclosure be finishing (i.e. drywall) to avoid exposed insula-
tion or vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is
maintained.
FIG. 1
FIG. 3
12
W415-2212 / 08.22.17
FIG. 4
FIG. 2
FIG. 5