Operation; Operating Control Panel - Napoleon ALLURAVISION Serie Manuel D'installation Et D'utilisation

WARNING
!
• While the appliance is operating, do not remove the glass panel. This will cause the remote control and
touch panel to disfunction.
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
ATTENTION: Ensure the house circuit breakers for the power supply are turned on. In the event of
a power failure, the appliance will lose its memory function and will reset to factory mode when the
power returns.
8.1

operating control panel

The control panel is located on the lower right of the appliance.
Power
Yellow Flame
Blue Flame
Heater
Ember Bed Light
ºF / ºC
Heater Lock
Temperature
Control
Turns the appliance on/off.
Controls flame brightness.
Settings:
F0 - Flame off
F1 - Small flame
F2 - Medium flame
F3 - Bright flame
F4 - Brightest flame
Turns the heater and blower on/off.
Settings:
H0 - Heater and blower off
BL - Blower on
H1 - Low heat
H2 - High heat
H3 - High heat with blower boost
Controls ember bed light settings.
Settings:
L0 - Ember bed light off
L1 - White
L2 - Blue
L3 - Green
L4 - Red
L5 - Yellow
L6 - Purple
L7 - Auto-cycle from white, orange, blue, orange-blue, white-
orange, white-blue (It will take 8.5 seconds to switch between
colours)
L8 - Lock to desired color
To change the temperature to Celsius or Fahrenheit, press
and hold the yellow flame button for 5 seconds.
hold 5 seconds
Heater button can be locked or unlocked by holding the
heater button for 5 seconds.
hold 5 seconds
Press and hold the blue flame button for 5 seconds. This will
change the button to temperature control, or vice-versa. There
hold 5 seconds
are 7 temperature settings (61ºF [16ºC], 64ºF [18ºC],
70ºF [21ºC], 75ºF [24ºC], 81ºF [27ºC], 85ºF [29ºC], and OFF)

8.0 operation

operation
W415-2212 / 08.22.17
EN
23