Device Communication; Dip Switch Settings - Honeywell IAQPoint2 Guide De Démarrage Rapide

This device is a slave device must be integrated into a Floor Level
Network, called FLN, with a master (controller, software, etc.). Vulcain
devices respond to P1 commands.

Dip Switch Settings

The detector address is selected (in binary format) with dip switches D6 to
D0 (MSB to LSB) on SW3.
The dip switch is labeled 1 through 8. Switch 8 (binary value D7 on the
circuit board) is the assigned "LOCK" switch, which locks the Zero and
Span keys to prevent accidental activation. Switches labeled 1 through 7
each represent a binary value on the circuit board (D0 to D6). Each of
these switches is associated to a value, known as a "weight", assigned to
its ON position (the OFF position has no value), as shown in the table
below:
Switch
Number
1
2
3
4
5
6
7

Device Communication

8 7
Binary
PCB Value
number
D0
D1
D2
D3
D4
D5
D6
901T User Manual
SW3
6 5 4 3 2 1
ON
1
2
4
8
16
32
64
Device Communication
Dip Switch Settings
17